Testing Environment =============================== Host: routerstationpro Kernel: Linux routerstationpro 2.6.34.7-wr-standard-08672-g2ec2eda Image location: http://autobuilder.pokylinux.org/nightly/20110121-1/machines/routerstationpro/mips/ Steps =============================== 1. Boot up the routerstationpro with sdk image 2. run 'dmesg' on target Observed Result =============================== There isn't have bootup message display. root@routerstationpro:~# dmesg mode eth0: processing TX ring eth0: 0 packets sent out eth0: processing RX ring eth0: rx packets, limit=64, curr=40309, dirty=40309 eth0: 1 rx descriptors refilled eth0: rx finish, curr=40310, dirty=40310, done=1 eth0: disable polling mode, rx=1, tx=0,limit=64 eth0: packet injected into TX queue eth0: raw intr=00000001 TXPS ... eth0: 1 packets sent out eth0: processing RX ring eth0: rx packets, limit=64, curr=40597, dirty=40597 eth0: 0 rx descriptors refilled eth0: rx finish, curr=40597, dirty=40597, done=0 eth0: disable polling mode, rx=0, tx=1,limit=64 eth0: raw intr=00000010 RXPR eth0: enable polling mode eth0: processing TX ring eth0: 0 packets sent out eth0: processing RX ring eth0: rx packets, limit=64, curr=40597, dirty=40597 eth0: 1 rx descriptors refilled eth0: rx finish, curr=40598, dirty=40598, done=1 eth0: disable polling mode, rx=1, tx=0,limit=64 root@routerstationpro:~#
These appear to messages from the ethernet driver. It could be that the driver included with this release has more debug enabled.